Sale!

HAPPYMODEL Mobeetle6 Racer Drone

$211.99

Description

HAPPYMODEL Mobeetle6 Racer Drone 1S 65mm Whoop and Toothpick 2-in-1 Come with DiamondF4 Flight Controller Built-in OPENVTX Low Profile Canopy (Compatible with FrSky)

  • Item Name: The Lightest 1S Mobeetle6 Racer Drone whoop and toothpick 2-IN-1 , 65mm Frame 2pcs.
  • AIO 5in1 F4 Flight Controller: Inspired by Angry-Don, The Mobeetle6 Come with DiamondF4 Flight Controller that Built-in Betaflight OSD(SPI Control), 5-8G OPEN VTX , 5V 1A BEC, and 5A(each) Blheli_S 4in1 ESC Dshot600 ready.
  • ELRS Receiver Version: Built-in Onboard SPI ELRS V2.0 Receiver, Compatible with ExpressLRS V2.0 TX Module. Receiver Protocol:  SPI ExpressLRS.
  • Compatible with FrSky Version: Built-in SPI D8 Receiver , Compatible with Frsky Non EU transmitter D8 model.
  • The Mobeetle6 Wheelbase: 65mm, Size: 80*80*30mm. Motor: SE0702 23000KV Unibell brushless motors. Lightweight only 17.5g (without battery).

Specifications:

Flight Controller
( Compatible with Frsky SPI RX version) DiamondF4 FR FC Firmware target: CrazybeeF4FR
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)
Original whoop size compatible
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5-8G OPEN VTX
Built-in SPI ELRS V2.0/Compatible Frsky receiver
Built-in 5V 1A BEC

Onboard SPI ExpressLRS 2-4GHz Receiver
Packet Rate option: 50Hz/150Hz/250Hz/500Hz
ExpressLRS Firmware version: V2.0
RF Frequency: 2-4GHz
Antenna : Enameled copper wire antenna
Telemetry output Power: <12dBm
Receiver protocol:  SPI ExpressLRS
Compatible with ExpressLRS V2.0 TX Module
Couldn`t flash separately ExpressLRS firmware

Onboard 4in1 ESC
MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_50_REV16_8.HEX
Default protocol: DSHOT600

Propeller
Gemfan 1210 31mm propeller(4cw+4ccw)
Weight:0.19g
Material:PC
Pitch:1 inch
Props Dia:30mm
Center Hole Dia:1mm

Motor: 
Mode:SE0702 KV23000
Configu-ration:9N12P
Stator Diamter:7mm
Stator Length:2mm
Shaft Diameter:?1mm
Motor Dimension(Dia.*Len):?9.5mm*14mm
Weight(g):1.5g
No.of Cells(Lipo):1S only

Lipo Battery
Capacity:300mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Size: 57mmx12mmx7mm
Weight: 7.5g
Connector: PH2.0